To install a caster assembly:
the assemblies to be sure each caster rolls freely. If there is a problem
with any part of the caster assembly, do not install the assembly. Contact
Customer Support and report
Inside the UPS cabinet, locate the envelope containing eight nuts and eight
lockwashers. Remove the envelope and set it aside. Close the cabinet door.
one of the caster assemblies and slide it, at an angle, into one of the forklift
openings on the bottom of the cabinet.
Each caster assembly
on four studs (two at the front and two at the back) on
the bottom of the cabinet (see Figure
There are holes in the caster assembly
that fit over these studs.
UPS
(view from underneath)
F/gum
Because of the height of the caster assembly, you cannot hold the assembly
parallel with the base of the cabinet while you slide it into the channel. Tilt the
inner edge of the assembly upward to slide into the channel (see
8).
Power-ware Plus UPS Installation Manual
15
Summary of Contents for Plus 80
