Power Electronics SDRIVE 700 Series, Getting Started Manual

Page: 49 / 130

SDRIVE 700
POWER ELECTRONICS
48
DESCRIPTION OF PROGRAMMING PARAMETERS
Parameter
Name /
Description
Range
Default
value
Function
Set on
RUN
3 LOCAL SP=+100%
LOCAL SPEED
G3.3 / Local
Speed
Reference
-250 to
+250%
+100%
It allows user to set the motor speed value if the reference source
for speed has been set to 'LOCAL'.
YES
10.4. Group 4 – G4: Inputs
10.4.1. Subgroup 4.1 – S4.1: Digital Inputs
Parameter
Name /
Description
Range
Default
value
Function
Set on
RUN
1 CNTROL MODE1=1
G4.1.1 / Main
Control Mode
0 – 3 1
It allows user to set the control mode for the drive commands
(Start/Stop, Reset, ...).
OPT DESCRIPTION FUNCTION
0 NONE Control mode 1 is not operative.
1 LOCAL Drive control is done by keypad.
2 REMOTE
Drive controlled through control
terminals.
3 SERIAL COMMS
Drive controlled through
communication bus.
NO
2 CNTROL MODE2=2
G4.1.2 /
Alternative
Control Mode 0 – 3 2
It allows user to set the secondary control mode for the drive
commands (Start/Stop, Reset, ...).
OPT DESCRIPTION FUNCTION
0 NONE Control mode 2 is not operative.
1 LOCAL Drive control is done by keypad.
2 REMOTE
Drive controlled through control
terminals.
3 SERIAL COMMS
Drive controlled through
communication bus.
Note: Control mode 2 will be activated through digital inputs
exclusively. To use this set one of the digital inputs to '17
Î
CONTROL 2'. When this input is activated, auxiliary control mode
will be activated.
NO
3 RESET MODE=Y
G4.1.3 / Reset
from keypad
N
Y
Y
It allows user to reset faults from the keypad unit (LOCAL).
OPTION FUNCTION
N=NO It is not possible to reset from the keypad unit.
Y=YES
The drive can be reset via the reset button on the
keypad unit.
YES