Page 4
www.poolpro.com.au
personal injury the Power Pack is designed so that the Electrolytic Cell will only
receive power when the pool pump is on. Otherwise, dangerous chlorine gas
build-up can occur. If the pump is not installed to the AC Socket (pump outlet) on
the Power Pack, then the installer must ensure that the Electrolytic Cell is never
energized when the pool pump is OFF, or water is not flowing through the unit.
●
Read and keep your user manual in a safe place.
●
Increase chlorine production when temperature goes up.
●
Use Stabiliser to stabilise chlorine in the swimming pool.
●
Ideal salt levels range between 3000-3500ppm (parts per million). Salt levels below
3000ppm and above 4000ppm may damage equipment and void any warranty.
●
Decrease production when temperature goes down - see Section 12.3 WINTER/
BLANKET MODE.
●
Disclaimer: Information in this guide is intended to provide general information
on a particular subject(s) in good faith and is not an exhaustive treatment of such
subject(s). Its use is beyond the control of the author, contributor, publishers,
and distributors and should not be relied upon without consulting your local
Professional for comprehensive advice. This guide includes subject(s) that should
only be performed by or under the direction and advice of your local Professional
and under no circumstances should the guide be used as a substitute for such
professionals. No representations or warranties are made that the content, advice,
and recommendations in this guide are current, free from errors or omissions, or
appropriate for the user’s circumstances or abilities. No liability is accepted for any
loss suffered as a result of any user’s reliance on such content.
2. PACKAGING CONTENTS
Wall
mounting
bracket
Power
pack
Cell housing with
unions
2 x 50/40
reducing
bushes
2 x green
wall plugs
with screws
User
manual
3. TOOLS NEEDED
Drill with
6mm drill bit
Basic PVC
fittings
Hacksaw
PVC primer &
PVC cement
“Type P” for
pressure pipes
No.2
Phillips head
screwdriver
