Page 10
www.poolpro.com.au
10. INITIAL START-UP
On initial startup of your Neptune chlorinator, the screen will run through a start-up
sequence. Please wait until “START UP CLOCK SET” is displayed.
SETTING THE CLOCK (time of day)
1.
“START UP CLOCK SET” will display on the LCD screen.
2.
“00” will flash for Hours. Press
or
to change the hour. Press
to save.
3.
“00” will flash for Minutes. Press
or
to change the minutes. Press
to
save.
SETTING THE TIMER / RUN PERIOD (daily run times of the chlorinator)
1.
“START UP RUN PERIODS” will display on the LCD screen. “2 CYCLES/DAY” will
flash.
2.
Press
or
to scroll through the cycles.
Select from the following cycles for your chlorinator to operate:
(a) “2 CYCLES/DAY” = 6am - 10am and 4pm - 8pm
(b) “1 CYCLE AM” = 8am - 4pm
(c) “1 CYCLE PM” = 8pm - 4am
3.
Press
to save or press to exit without saving. If these cycle times are not
suitable, you can change them in the Clock/Timer function – see page 11-12.
SETTING UP THE POOL SIZE
1.
“START UP INFORMATION” will display on the LCD screen. The litre quantity for
“POOL SIZE” will flash.
2.
Press
or
to change the litre quantity by 1,000L increments, hold
or
to change the litre quantity by 5,000L increments.
3.
Press
to save or press to exit without saving.
SETTING UP THE MINERAL TYPE (if your pool uses salt or mineral mix)
1.
“START UP INFORMATION” will display on the LCD screen. “SALT” will flash.
2.
Press
or
to change the type of mineral used in the pool water. Select from
“SALT” or “MINERAL”.
3.
Press
to save or press to exit without saving.
