Page 14
www.poolpro.com.au
levels of salt/minerals, depending on the test results.
1.
Ensure the cell is clear of calcium deposits (which may affect test results).
2.
Press the
shortcut button or enter Salt Test via the Main Menu.
3.
The chlorinator will run a salt test, allow at least 30 seconds for an accurate reading.
The LCD screen will display the test results and any action needed to be taken.
4.
The chlorinator will then return to the Main Screen automatically.
12.6 SHORTCUT BUTTON: BACKWASH
This function assists you in the operation of your pump and filter during a backwash.
IMPORTANT: Never operate the filter’s multi-port valve lever while the pump is
running, as it may cause damage and leaking. The pump will start and stop as
you require. Ensure all valves, valve handles, lids, baskets etc are in the correct
positions as per the requirements of the manufacturer of the equipment.
1.
Press the
shortcut button or enter Backwash via the Main Menu. The LCD
screen will display “BACKWASH MODE”.
2.
Rotate the filter’s multi-port valve lever to the ‘Backwash’ position and ensure the
handle locks in place. This step is not applicable for cartridge filters.
3.
Press
to begin the backwash cycle. The pump will start and run for 2 minutes.
A countdown timer will display on the LCD screen. Press
to increase the run
time by 1 minute if desired. If you need to stop the pump during the cycle, press
to stop the pump immediately. Press
to start the pump again.
4.
When the cycle has finished the pump will stop. Ensure the water in the filter’s sight
glass is clear, then press
. The LCD screen will display “RINSE MODE”.
5.
Rotate the filter’s multi-port valve lever to the ‘Rinse’ position and ensure the handle
locks in place. This step is not applicable for cartridge filters.
6.
Press
to begin the rinse cycle. The pump will start and run for 1 minute.
A countdown timer will display on the LCD screen. Press
to increase the run
time by 1 minute if desired. If you need to stop the pump during the cycle, press
to stop the pump immediately. Press
to start the pump again.
7.
When the cycle has finished the pump will stop. Ensure the water in the filter’s
sight glass is clear, then press
. The LCD screen will display “BACKWASH
COMPLETED”.
8.
Rotate the filter’s multi-port valve lever to the ‘Filter’ position and ensure the handle
locks in place. This step is not applicable for cartridge filters.
9.
Press
to confirm the filter’s multi-port valve lever is set to the ‘Filter’ position.
