9926813 R04 - 2013-2016
RZR
570 Service Manual
© Copyright Polaris Industries Inc.
2.35
BATTERY INSTALLATION
NOTE
Using a new battery that has not been fully charged can
damage the battery and result in a shorter life. It can
also hinder vehicle performance. Follow the battery
charging procedure in Chapter 10 “Electrical” before
installing the battery.
1.
Ensure the battery is fully charged.
2.
Place the battery in the battery holder and secure
with hold-down strap.
3.
Coat
the
terminals
with
dielectric
grease
or
petroleum jelly.
4.
Connect and tighten the two red
q
(positive) cables
first.
5.
Connect and tighten the two black
w
(negative)
cable last.
CAUTION
The battery in some vehicles may be rotated 180°. This
results in the terminals being in different locations than
the image shown above.
6.
Verify that cables are properly routed and reinstall
the driver’s seat.
BATTERY OFF SEASON STORAGE
Whenever the vehicle is not used for a period of three
months or more, remove the battery from the vehicle,
ensure that it's fully charged, and store it out of the sun in
a cool, dry place. Check battery voltage each month
during storage and recharge as needed to maintain a full
charge.
NOTE
Battery charge can be maintained by using a Polaris
battery tender charger or by charging once a month to
make up for normal self-discharge. Battery tenders can
be left connected during the storage period, and will
automatically charge the battery if the voltage drops
below a pre-determined point.
SPARK PLUG SERVICE
1.
Remove the driver’s seat and disconnect the (-)
negative battery cable from the battery.
2.
Remove cargo box access panel.
WARNING
A hot exhaust system and engine can cause serious
burns. Allow engine to cool or wear protective gloves
when removing the spark plugs.
3.
Clean top of engine to remove all dirt and debris.
4.
Remove the spark plug wire
q
from the engine.
5.
Remove spark plug.
