11.34
9926813 R04 - 2013-2016
RZR
570 Service Manual
© Copyright Polaris Industries Inc.
HEADLAMP HOUSING INSTALLATION
1.
Install the headlamp housing back into the front
bumper.
2.
Secure the headlamp housing with the rubber O-
rings (A) on both sides of the headlamp and install
the adjustment screw (B).
3.
Reconnect
wire
harness
or
re-insert
bulb
if
previously removed.
4.
Adjust headlights using the “Headlight Adjustment”
procedure in this section.
BULB REPLACEMENT
Before replacing the bulb(s), use a digital multi-meter to
test the harness to ensure the lamp is receiving 12 volts
and that a ground path is present.
If a tail light, brake light or turn signal (INTL Only) does
not work the bulb may need to be replaced.
1.
Disconnect the wire harness.
2.
Remove bulb by turning the rubber base 1/4 turn and
pulling the bulb out. Replace it with recommended
bulb. Apply Dielectric Grease (PN 2871329).
3.
Test the tail light, brake light and turn signal (INTL
Only) to verify it is working properly.
