9926813 R04 - 2013-2016
RZR
570 Service Manual
© Copyright Polaris Industries Inc.
5.13
PVT BREAK-IN (DRIVE BELT / CLUTCHES)
A proper break-in of the clutches and drive belt will
ensure a longer life and better performance. Break in the
clutches and drive belt by operating at slower speeds
during the 10 hour break-in period as recommended (see
Chapter 3 – Engine Break-In Period, page 3.37 for
break-in example). Pull only light loads. Avoid aggressive
acceleration and high speed operation during the break-
in period.
CLUTCH CENTER DISTANCE
INSPECTION
1.
Remove the outer PVT cover, drive belt, drive clutch
and driven clutch as outlined in this chapter.
NOTE
The inner PVT cover does not need to be removed to
check the clutch center to center distance.
2.
Install the Clutch Center Distance Tool (PU-50658)
onto the crankshaft and transmission input shaft. The
pictures below show the tool properly installed.
NOTE
The Clutch Center Distance Tool is used for the center-
to-center distance only. Make sure that the tool is
laterally aligned well with the machine and not binding
on the shafts.
3.
If the tool fits as shown above, the clutch center to
center distance is correct.
4.
If the tool does not fit as shown above, adjustment is
needed.
