9926813 R04 - 2013-2016
RZR
570 Service Manual
© Copyright Polaris Industries Inc.
9.23
CALIPER ASSEMBLY
1.
Install new O-rings in the caliper body. Be sure the
grooves are clean and free of residue or brakes may
drag upon assembly.
2.
Coat pistons with clean Polaris DOT 4 Brake Fluid.
Install pistons with a twisting motion while pushing
inward. Piston should slide in and out of bore
smoothly, with light resistance.
3.
Lubricate the mounting bracket pins with silicone
grease and install the rubber dust seal boots.
4.
Compress the mounting bracket and make sure the
dust seal boots are fully seated. Install the brake
pads. Clean the disc and pads with brake parts
cleaner or denatured alcohol to remove any dirt, oil
or grease.
CALIPER INSTALLATION
1.
Install the brake line onto the caliper taking care not
to allow any debris to enter the caliper.
2.
Install the caliper and torque the
new
mounting bolts
to specification.
TORQUE
Front Caliper Mount Bolt:
30 ft-lbs (41 Nm)
3.
Torque
the
banjo
bolt
to
the
proper
torque
specification.
4.
Install the adjustment set screw and turn clockwise
until stationary pad contacts disc, then back off 1/2
turn (counterclockwise).
5.
Perform brake bleeding procedure as outlined earlier
in this chapter.
