The cabling of the second set of photocells is not possible to make in case of this drive assembly.
Installation
After connecting the cables to the photocells it is necessary to:
•
turn off the drive’s power supply,
•
launch the gate opening and closing mode.
Photocells are recognised by the electronic control system after this
movement is finished.
Operation with the use of photocells
if the photocells are obscured when the gate is being closed, the gate stops
and then starts opening again.
In case of removal of photocells
After removing photocells, turn on the drive power supply again
and then carry out the “Deactivation of automatic closing” procedure, page 39.
Orange light (option)
Lamp - 10 W and 24 V MAXIMUM - Using a lamp with power of more than 10 W - 24 W may cause incorrect
functioning of the drive assembly.
Orange light functioning
The orange light flashes when the gate is moving.
