2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
70
The security method of
SNMP
v3
uses account/password for authentication. “Security
Name” is the account name to be used with your “Password”. The default security name is
“public” and the password must be at least 8 characters long. You also can set any other
security name or password. Click “
Apply
” after you’ve completed the setup.
SNMP function is now enabled. You may now install and run the SNMP management
software on computer server.
SNMP Trap Usage:
SNMP traps enable notifications from devices. Devices may send message to the
management server whenever significant events occur such as cold start, warm start and
authentication failure. The manager will get the information immediately and take action if
necessary.
Cold start
means device reboot by power disconnection.
Warm start
means device reboot
by firmware without power disconnection. If there are other parties that attempt to connect to
the device with a wrong security password under SNMP v1, v2 or v3 setting, the device will
send an
authentication failure
message to the management server.
To enable SNMP Trap function in the camera, type the IP address of the computer running
the SNMP management software and type trap community as password to allow server to
get trap message from device (Default is public). Select available traps and click “
Apply
”.
Camera’s SNMP offers the following information:
Group
Description
System
Provides general information about the managed device.
For example, system description and system name.
Interface
Provides general information from the physical interfaces.
For example, interface speed and MAC address.