2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
153
Appendix J. Troubleshooting & Frequently
Asked Questions
Installing this device
The device will be installed
and work if a firewall exists on
the network.
If a firewall exists on the network, the HTTP port, Control Server and Streaming
Server ports need to be opened on the firewall or NAT router.
By default, the TTP port is 80; Control Server port is 6001; Streaming Server port is
6002.
The username and password
used for the first time or after
factory default reset
Username =
admin
and password =
admin
.
Note that it’s all case sensitive.
Forgot the username and
password
Follow the steps below.
1.
Power on the camera. Wait for 2 minutes until it is ready.
2.
Press and hold the hardware reset button for at least 5 seconds or until the
Power LED lights are off, and then release the button.
3.
It will take around 2 minutes to boot the camera.
4.
Re-login the camera using the default IP (
), and username
(admin), password (admin).
Forgot the IP address of the
device
Check IP address of device by using PLANET Smart Discovery Lite program or by
UPnP discovery or set the device to default by reset button.
PLANET Smart Discovery Lite
program
cannot
find
the
device.
Re-power the device if the unit cannot be found within 1 minute.
Do not connect device over a router. PLANET Smart Discovery Lite program
cannot detect device over a router.
If IP address is not assigned to the PC that runs PLANET Smart Discovery Lite
program, then PLANET Smart Discovery Lite program cannot find device. Make
sure that IP address is assigned to the PC properly.
Antivirus software on the PC might interfere with the setup program. Disable the
firewall of the antivirus software during setting up this device.
Check the firewall setting of your PC or Notebook.
Internet Explorer does not
seem to work well with the
device
Make sure that your Internet Explorer is version 11. If you are experiencing
problems, try adding the camera’s IP address to the IE11’s compatible list.
PLANET Smart Discovery Lite
program fails to save the
network parameters.
Network may have trouble. Confirm the parameters and connections of the device.