Summary
Specifications
LX-PR-65S-Z Infrared Sensor Instruction
123mm
76mm
100mm
Detection range
（
22
℃）
10m
Detection angle
110°
Sensor information
This product is an advanced digitally controlled infrared pyroelectric intelligent sensor product.This product uses one
high-resolution sensor that is almost twice the sensitivity of a single traditional sensor.It uses the MCU to accurately
calculate the switch information, and accurately controls the relay to be turned on at the zero point of the sine wave, so
that each load is turned on. At the zero point of the sine wave, the inrush current problem caused by the conventional
control mode when the sine wave high voltage is turned on is avoided, especially the large current damage relay
generated by the large-capacity capacitor under the impact of the high voltage under the load.
Due to the diversification of current electrical loads, especially LED lamps, energy-saving lamps, and fluorescent lamps
all have capacitors with different capacitances. This is a disaster for relays. Sometimes a 50W LED lamp can generate
surge currents of 80 to 120A. The 10A ordinary relay can only withstand 3 times of the inrush current, and it is likely that
the relay will be broken in a few days or several times. This is why the conventional sensor on the market has a short
life and a small load current.
In order to overcome this problem, this product adopts advanced digital precision calculation to turn on the load when
the sine wave is at zero potential, thus solving the load surge current problem, greatly enhancing the load capacity and
prolonging the service life of the product. The latest control method of mass production sensor technology can easily
control any load. It is a medium and high-end product. Although the cost is increased compared with the conventional
version, the reliability and life of the product are greatly increased. This product is equal to choosing peace of mind, and
choosing safety.
This product has a switching power supply version and a capacitor step-down version. The switching power supply
version has a working voltage of up to 100V-277V and a standby power consumption of <0.5W. In principle, the
capacitive step-down version can only have a single voltage, and the standby power consumption is >0.7W. You should
consider it when choosing a product.
Power source: 220-240VAC,50Hz/60Hz
100-130VAC,50Hz/60Hz
All loads
：
1200W
（
220-240VAC
）
800W
（
100-130VAC
）
Detection angle: 110º(adjustable)
Time setting: 10sec-12min (adjustable)
Detection range(22°C): 10m Max.
Working temperature: -10°C-+40°C
Working humidity: <93%RH
Light-control:
＜
10LUX-2000LUX (adjustable)
Installation height: 1.8-2.5m
Detection motion speed: 0.6-1.5m/s
