Troubleshooting
Common
Symptom
Cause
Action (See)
Power doesn
’
t turn on.
The unit doesn
’
t operate.
Leads and connectors are incor-
rectly connected.
Confirm once more that all connections are
correct.
The fuse is blown.
Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install a fuse
with the same rating.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
Turn the unit off and then on.
Operation with the remote con-
trol isn
’
t possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed.
The remote control operation mode
is incorrect.
Switch to the correct remote control mode.
(Page 12)
Battery power is low.
Load new battery. (Page 7)
Some operations are prohibited
with certain discs.
Check by using another disc.
Playback is not possible.
The disc is dirty.
Clean disc. (Page 70)
The loaded disc is a type this unit
cannot play.
Check what type the disc is.
Non compatible video system disc
is loaded.
Change to a disc compatible to your video
system.
No sounds are heard.
The volume level will not rise.
Cables are not connected correctly.
Connect the cables correctly.
The unit is performing still, slow mo-
tion or frame-by-frame playback.
There is no sound during still, slow motion or
frame-by-frame playback.
The icon
is displayed, and op-
eration is not possible.
The operation is prohibited for the
disc.
This operation is not possible.
The operation is not compatible
with the disc
’
s organization.
This operation is not possible.
The picture stops (pauses) and
the unit cannot be operated.
Reading of data has become impos-
sible during playback.
After stopping playback once, start playback
once more.
There is no sound.
Volume level is low.
The volume level is low.
Adjust the volume level.
The attenuator is on.
Turn the attenuator off.
There is audio and video skip-
ping.
The unit is not firmly secured.
Secure the unit firmly.
The picture is stretched, the as-
pect is incorrect.
The aspect setting is incorrect for
the display.
Select the appropriate setting for your display.
(Page 40)
When the ignition switch is
turned ON (or turned to ACC),
the motor sounds.
The unit is confirming whether a
disc is loaded or not.
This is a normal operation.
Problems during DVD playback
Symptom
Cause
Action (See)
Playback is not possible.
The loaded disc has a different re-
gion number from this unit.
Replace the disc with one featuring the same
region number as this unit. (Page 5)
<
CRB2932-A/N
>65
Additional Information
En
65
Appendix
Additional
Information
