Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message
Cause
Action
ERROR-MIC
Microphone is not connected.
Plug the supplied microphone securely into
the jack.
ERROR-FSP
,
ERROR-FLSP
,
ERROR-FRSP
,
ERROR-CSP
,
ERROR-RSP
,
ERROR-RLSP
,
ERROR-RRSP
,
ERROR-SW
The microphone cannot pick up the
measuring tone of a speaker.
!
Confirm that the speakers are connected
correctly.
!
Correct the input level setting of the power
amp connected to the speakers.
!
Set the microphone correctly.
ERROR-NOIS
The surrounding noise level is too
high.
!
Stop your car in a place that is as quiet as
possible, and switch off the engine, air condi-
tioner or heater.
!
Set the microphone correctly.
<
CRB2932-A/N
>69
Additional Information
En
69
Appendix
Additional
Information
