Phytec phyCORE-P87C591, Quick Start Instructions

Page: 10 / 84

phyCORE-P87C591 QuickStart Instructions
6
© PHYTEC Meßtechnik GmbH 2002 L-586e_2
The phyCORE Development Board LD 5V, in EURO-card
dimensions (160 x 100 mm), is fully equipped with all mechanical
and electrical components necessary for the speedy and secure
insertion, and subsequent programming, of PHYTEC
phyCORE
series Single Board Computers with standard width
(2.54 mm/ 0.10 in.) pin header connectors. Simple jumper
configuration readies the Development Board’s connection to any
phyCORE module (standard header pins), which plug pins-down into
the contact strips mounted on the phyCORE Development
Board LD 5V.
phyCORE Development Board LD 5V Technical Highlights
•
Reset signal controlled by push button or RS-232 control line
CTS0
•
Boot signal controlled by push button or RS-232 control line
DSR0
•
low voltage socket for supply with regulated input voltage 5 VDC
•
additional supply voltage 3.3 VDC
•
two DB-9 sockets (P1A, P1B) configurable as RS-232 interfaces
•
two additional DB-9 plugs (P2A, P2B) configurable as
CAN interfaces, connector P2B optionally configurable as RS-485
interface
•
simple jumper configuration allowing use of the
phyCORE Development Board LD 5V with various PHYTEC
phyCORE SBC’s
•
one control LED D3 for quick testing of user software
•
2 x 160-pin Molex connector (X2) enabling easy connectivity to
expansion boards (e.g. PHYTEC GPIO Expansion Board)