Connecting cables
79
SmartNode 1000 and 2000 Series Getting Started Guide
5 • SmartNode 1400 installation
Figure 48. SmartNode 1400 connectors
Connecting cables
Installing SmartNode 1400 cables takes place in the following order:
1. Installing the 10Base-T Ethernet cable into ports ETH 0 and ETH 1 (see
figure 48
) (see
“Installing the
Ethernet cables”
on page 79).
2. Installing the BRI 0 and BRI 1 cables (see
“Installing the BRI cables”
on page 80).
3. Installing the power cord (see
“Installing the power cord”
on page 84).
Installing the Ethernet cables
Ethernet devices (10Base-T) are connected to the SmartNode’s Ethernet ports (see
table 24
for port pin-out
listing) via a cable terminated with RJ-45 plugs. Use a cross-over cable to connect to a host (see
figure 49
on
page 80), or a straight-through cable to connect to a hub (see
figure 50
on page 80).
Note
Pins not listed are not used.
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
Table 24. Ethernet 10Base-T (RJ-45) port pin-outs
Pin
Signal
1
TX+
2
TX-
3
RX+
6
RX-
ETH 1
10Base-T (LAN)
port
ETH 0
10Base-T (Modem)
port
BRI 1
ISDN S (Phone)
port
BRI 0
ISDN T (Line)
port
CONSOLE
RS-232
port
100–240 VAC
50/60 Hz
power connector
ISDN S/T
ISDN S/T
WARNING
