Hardware installation
77
SmartNode 1000 and 2000 Series Getting Started Guide
5 • SmartNode 1400 installation
Hardware installation
SmartNode 1400 installation consists of the following:
•
Placing the device at the desired installation location (see section
“Mounting the SmartNode 1400”
on
page 77)
•
Installing the interface and power cables (see section
“Connecting cables”
on page 79)
When you finish installing the SmartNode 1400, go to chapter 10,
“Quick start”
on page 126.
Mounting the SmartNode 1400
The SmartNode 1400 should be placed in a dry environment with sufficient space to allow air circulation
for cooling.
Note
For proper ventilation, leave at least 2 inches (5 cm) to the left, right,
front, and rear of the SmartNode 1400.
The SmartNode 1400 can be installed as follows:
•
Placed on a desktop or similar sturdy, flat surface that offers easy access to the cables
•
Mounted on a wall
Desktop installation
Do the following to install the SmartNode 1400:
1. Remove one of the rubber pads from the adhesive strip (included in the SmartNode installation kit pack)
and place it on a corner on the bottom of the SmartNode 1400 (see
figure 46
).
Figure 46. Pads and wall-mounting keyholes locations
Wall mounting keyholes
Model
Serial No.
Part No.
Eth0 Mac
Eth1 Mac
SN14000 0001-0001
100000020153
40-0003
00.30.2E.00.06.94
00.30.2E.00.08.96
Pad (4 places)