Hardware installation
67
SmartNode 1000 and 2000 Series Getting Started Guide
4 • SmartNode 1200 installation
Hardware installation
SmartNode 1200 installation consists of the following:
•
Placing the device at the desired installation location (see section
“Mounting the SmartNode 1200”
on
page 67)
•
Installing the interface and power cables (see section
“Connecting cables”
on page 69)
When you finish installing the SmartNode 1200, go to chapter 10,
“Quick start”
on page 126.
Mounting the SmartNode 1200
The SmartNode 1200 should be placed in a dry environment with sufficient space to allow air circulation
for cooling.
Note
For proper ventilation, leave at least 2 inches (5 cm) to the left, right,
front, and rear of the SmartNode 1200.
The SmartNode 1200 can be installed as follows:
•
Placed on a desktop or similar sturdy, flat surface that offers easy access to the cables
•
Mounted on a wall
Desktop installation
Do the following to install the SmartNode 1200:
1. Remove one of the rubber pads from the adhesive strip (included in the SmartNode installation kit pack)
and place it on a corner on the bottom of the SmartNode 1200 (see
figure 36
).
Figure 36. Pads and wall-mounting keyholes locations
Wall mounting keyholes
Model
Serial No.
Part No.
Eth0 Mac
Eth1 Mac
SN14000 0001-0001
100000020153
40-0003
00.30.2E.00.06.94
00.30.2E.00.08.96
Pad (4 places)
