Introduction
127
SmartNode 1000 and 2000 Series Getting Started Guide
10 • Quick start
Introduction
This chapter leads you through the basic steps to set up a new SmartNode and to download a configuration.
Patton SmartNodes can be used for a wide variety of IP-based network applications. To support and ease the
configuration of the SmartNodes configuration, templates for the most important applications are available on
the Patton server at www.patton.com/voip.
The main steps for setting up a new SmartNode (as of release 2.00 or 2.10) are shown in
figure 85
.
Figure 85. Steps for setting up a new SmartNode
1
Configure IP address
2
Connect the SmartNode to the network
3
Load configuration
Console port
Serial
interface
PC or workstation
with VT-100
emulation terminal
Ethernet interface
ETH0
Network
interface
PC or workstation
or VT-100 emulation
terminal
Network
2. Modify configuration
Network
Internet
3. Load configuration
1. Download configuration example
Patton Web server
with configuration examples
SmartNode 1400
To
IP Integrated Access Device
POWER
RUN
BRI 0
BRI 1
ETH 0
ETH 1
SmartNode 1400
To
IP Integrated Access Device
POWER
RUN
BRI 0
BRI 1
ETH 0
ETH 1
SmartNode 1400
To
IP Integrated Access Device
POWER
RUN
BRI 0
BRI 1
ETH 0
ETH 1
Note
You can manually configure the
SmartNode. You do not have to load a
configuration file.
