Connecting cables
93
SmartNode 1000 and 2000 Series Getting Started Guide
6 • SmartNode 2300 installation
Note
Some NTUs have non-standard or mirrored connections and require
special cables. Consult the NTU maker’s product documentation.
Installing the interface card cables
The following interface cards are available for use with the SmartNode 2300:
•
IC-4FXS
—Gateway interface card for 4 analog FXS ports (see section
“Installing the IC-4FXS interface
card cables”
)
•
IC-4BRV-8V
—8-channel gateway interface card for ISDN BRI (see section
“Installing the IC-4BRV-8V
interface card cables”
on page 94)
•
IC-E1V
—30-channel E1 gateway interface card for ISDN PRI (see section
“Installing the IC-E1V interface
card cables”
on page 96)
•
IC-T1V
—23-channel T1 gateway interface card for ISDN PRI (see section
“Installing the IC-T1V inter-
face card cables”
on page 97)
Determine which cards are installed in your SmartNode 2300, then go to the appropriate section to install
the device.
Installing the IC-4FXS interface card cables
The IC-4FXS supports up to four analog connections (see
table 28
for port pin-out listing) via cables termi-
nated with RJ-12 plugs (see
figure 61
on page 94).
Note
The IC-4FXS is actually equipped with RJ-11 sockets. An RJ-11
socket is similar to an RJ-12 socket but pins 1 and 6 are omitted.
Note
Pins not listed are not used.
Table 29. RJ-12 socket
Pin
Signal
3
Ring (-)
4
Tip (+)
