Connecting cables
71
SmartNode 1000 and 2000 Series Getting Started Guide
4 • SmartNode 1200 installation
ing a BRI to an ISDN telephone, see
figure 41
, or see
figure 42
on page 72 if you are connecting a BRI to an
NT. For BRI ports with configurable pin outs ensure that the appropriate mode (NET or USR) is configured.
Note
Pins not listed are not used.
Figure 41. Connecting a BRI to an ISDN telephone
Table 22. BRI (RJ-45) port pin-outs
Pin
Signal (USR)
Signal (NET)
3
TX+
RX+
4
RX+
TX+
5
RX-
TX-
6
TX-
RX-
Hazardous network voltages are present in the BRI cables. If you detach the
cable, detach the end away from the SmartNode or interface card first to avoid
possible electric shock. Network hazardous voltages may be present on the
device in the area of the BRI port, regardless of when power is turned OFF.
To prevent damage to the system, make certain you connect the
BRI cable to the BRI port only and not to any other RJ-45 socket.
WARNING
CAUTION
ISDN phone
S-Bus cable
RJ-45, male
Rx+
Tx-
Tx-
Rx-
3
4
5
6
RJ-45, male
3
4
5
6