![Patton electronics SMARTNODE 1200 Getting Started Manual Download Page 69](http://html2.mh-extra.com/html/patton-electronics/smartnode-1200/smartnode-1200_getting-started-manual_4022489069.webp)
Connecting cables
69
SmartNode 1000 and 2000 Series Getting Started Guide
4 • SmartNode 1200 installation
Figure 38. SmartNode 1200 connectors
Connecting cables
Installing SmartNode 1200 cables takes place in the following order:
1. Installing the 10Base-T Ethernet cable into ports ETH 0 and ETH 1 (see
figure 38
) (see
“Installing the
Ethernet cables”
on page 69).
2. Installing the BRI 0 and BRI 1 cables (see
“Installing the BRI cables”
on page 70).
3. Installing the power cord (see
“Installing the power cord”
on page 75).
Installing the Ethernet cables
Ethernet devices (10Base-T) are connected to the SmartNode’s Ethernet ports (see
table 21
for port pin-out
listing) via a cable terminated with RJ-45 plugs. Use a cross-over cable to connect to a host (see
figure 39
on
page 70), or a straight-through cable to connect to a hub (see
figure 40
on page 70).
Note
Pins not listed are not used.
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
Table 21. Ethernet 10Base-T (RJ-45) port pin-outs
Pin
Signal
1
TX+
2
TX-
3
RX+
6
RX-
ETH 1
10Base-T (LAN)
port
ETH 0
10Base-T (Modem)
port
BRI 1
ISDN S (Phone)
port
BRI 0
ISDN T (Line)
port
CONSOLE
RS-232
port
100–240 VAC
50/60 Hz
power connector
WARNING