Paradox Digiplex EVO192, Installation Manual, Page: 28 / 147

28 EVO Installation Guide
Programming Methods 3
3.1 Paradox Memory Key
The Paradox Memory Key can copy the programmed contents of one control panel into as many others.
Note:
Not to be used with UL Listed systems.
Copy to Memory Key
1. Insert the Memory Key (PMC-4) onto the control panel’s connector labelled “
MEM KEY
”.
2. To copy the contents to the Memory Key except zone numbering and sections [0501] to
[0532] , enter installer programming mode, then enter section [4020] . (Depending on the
memory key, the labels may or may not be included.)
To copy the contents to the Memory Key including zone numbering and sections [0501] to
[0532] , enter section [4021] . (Depending on the memory key, the labels may or may not be included.)
3. When the keypad emits a confirmation beep, remove the Memory Key. Remove the write protect jumper.
Download to Control Panel
1. Insert the Memory Key onto the control panel’s connector labelled “
MEM KEY
”.
2. To download the contents of the Memory Key except zone numbering and sections [0501] to
[0532] , enter installer programming mode and then enter section [4010] . (Depending on the
memory key, the labels may or may not be included.)
To download the contents of the Memory Key including zone numbering and sections
[0501] to [0532] , enter installer programming mode and then enter section [4011] .(Depending on the
memory key, the labels may or may not be included.)
3. When the keypad emits a confirmation beep, remove the Memory Key.
Figure 12: Using the Memory Key
3.2 Module Broadcast
Keypads and other modules can also be programmed easily by using Module Broadcast. Once a module is
programmed, its sections can be sent to other similar modules through the combus.
Jumper ON =
Can copy and
Jumper OFF =
Cannot override