Panasonic Workio DP-3510, Service Manual

Page: 625 / 858

625
JAN 2006 Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Fig. 7-005
e. If the stapling position is correct, set all bits on SW3 to OFF to end the adjustments. If you need to
change the stapling position, on the other hand, go to the next step.
f. To suit the position of the staple on the paper, press SW1 or SW2 on the Finisher Controller PCB as
many times as necessary.
• Pressing SW1 will shift the stapling position to the front in 0.3 mm increments.
• Pressing SW2 will shift the stapling position to the rear in 0.3 mm increments.
Fig. 7-006
g. Press SW1 and SW2 simultaneously.
• This will open the Swing Guide, and cause the feed belt to rotate. Placement of one sheet of A4/
LTR paper will cause the Finisher to start stapling.
h. Check the stapling position. If good, set all bits of SW3 to OFF. If re-adjustments are necessary, go
back to step f).
Caution:
The settings held by the Finisher Controller PCB are changed as soon as SW1 or SW2 is
pressed. As such, to recover the previous settings after the press, you must press the other of
the two Switches as many times as you pressed previously.
Guide Plate
Stapler
Alignment
Plate
Stopper
Stopper
290
±
2mm (A4)/
273
±
2mm (LTR)
Shift by
SW2 Shift by
SW1
Feeding direction
Paper
Staple