Panasonic Workio DP-3510, Service Manual

Page: 387 / 858

387
JAN 2006 Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Note:
See the Finisher's Installation Instructions for adjusting the height. If the 2 Bin Finisher (DA-FS600) or
the 2 Bin Saddle-Stitch Finisher (DA-FS605) is being installed at the same time as the Punch Unit and
you were asked to follow these instructions first before continuing with the Finisher installation. Return to
the step of the Finisher installation where you stopped and proceed installing the Finisher.
(8) Firmly connect the other end of the Punch Relay
Harness to Connector J21 and J23 on the
Finisher Controller PC Board.
Note:
Loose connections can result in malfunction. If the
Punch Unit malfunctions after installation, try
disconnecting and re-connecting the Connector.
(9) Install the Connector Cover 1 you removed
previously to the Rear Cover of the Finisher.
Note:
The Connector Cover 2 removed from the Rear
Cover of the Finisher will no longer be needed
when the Punch Unit is installed;
nevertheless, it may be a good idea to store it for
future use.
1. Secure the Connector Cover 1 with 2 Screws.
2. Open the Punch Unit.
(10) Jam Removal Instructions Label has already
been installed on the Punch Unit.
If other language is required, please attach the
required language sticker on it.
(11) Install the Upper Cover Grip as illustrated with 1
Silver Screw (M4 x 12).
Note:
If the Face Plate Button was installed to the
Finisher's Right Guide, the Guide Pin of the Upper
Cover Guide will not slide into the Right Guide
when the Upper Cover is closed. Be sure to
remove the Face Plate Button if it was installed.
(12) Plug the AC Power Cord into the wall outlet and
turn the Main Power Switch on the Back and the
Power Switch on the Left Side of the machine to
the ON position.
J21
Finisher Controller
PCB
Punch Relay
Harness
J23
Connector
Cover 1
(9)
Jam
Removal
Instructions
Label
Upper Cover
(11)
Upper Cover
Upper Cover
Guide