Panasonic Workio DP-3510, Service Manual

Page: 297 / 858

297
JAN 2006 Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Note:
1. Manual mode must be used, when updating the designated version of the firmware or changing
the type of the firmware.
Please refer to the Section 2.2, "Setting up the Network Firmware Update Tool, File Selection
Tab" of the Operating Instructions.
2. While updating the firmware code, the display may become garbled, however, it will return to
normal upon completion of the firmware update.
3. If the firmware update fails and the unit does not boot up, the Network Firmware Update Tool will
not be able to transfer the firmware code. If this occurs, please refer to the next section "Updating
through the Parallel Port" and use the Local Firmware Update Tool to recover the unit.
4. The suffix "_xx" for the Folder Name or File Name may not exist depending on the destination
location.
2. Updating through the Parallel Port (Alternate Method)
If the device is not connected to the LAN, upgrade the firmware code using the Parallel Port.
1)
Install the Local Firmware Update Tool to your PC
The option CD-ROM or the Panasonic Document Management System CD-ROM includes the Local
Firmware Update Tool and the Main Unit Firmware Code are located in the Option CD-ROM only.
Please refer to the following Operating Instructions to install the Local Firmware Update Tool.
Operating Instructions:
\xFirmware\Tools\Firmup\FIRMUP OI.pdf (Refer to the Local Firmware Update Tool OI on the CD)
Setup:
\xFirmware\Tools\Firmup\Setup\Setup.exe
2)
Preparing the Firmware Code
Double click the appropriate Destination Shortcut Batch File and copy the Firmware Code File on the
CD ROM to the Firmware Data Folder in your PC. Note that the files in the Archive will be extracted
automatically into the designated folder when the Archived file (.exe) is Double-clicked.
Example:
From:
Destination Shortcut Batch File: D:(CD-ROM Drive) \ xFirmware \ USA.bat
Firmware Code File:
DP-3520_4520_6020_xx_xxxxxx.exe
To:
Firmware Data Folder: C:\ Panasonic \ Panasonic-FUP \ Data
3)
Preparing the Main Unit for the Firmware Upgrade
Enter into Test Mode F9-07-01 to enable the unit to accept the programming code from the Parallel
Port.
If the unit does not boot up, follow the procedure below:
a. Turn the power Off (use the power switch on the back of the unit, not the side of the unit.).
b. Turn the power On while holding the [ENERGY SAVER] button.
c. When the unit's front panel green lamp turns On, release the [ENERGY SAVER] button, it is now
ready to accept the firmware code from the Parallel Port.
Connect the Parallel Cable between the Unit and PC.
Repeat the above steps if there are additional firmware code files to be updated.