Panasonic Workio DP-3510, Service Manual

Page: 131 / 858

131
JAN 2006 Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
3.6. Updating the Firmware
The Quickest and Most Reliable Way of Updating the Firmware is to use the Network Firmware
Program Tool (FUP) using Ethernet LAN Port and a Crossover Cable.
The network FUP Tool version must be 3.XX or higher, and it can be found on the CD included with PCL or
PS/PCL options.
Refer to the Firmware Update Operation Instructions and Service Notes for Option Instalation
(8.1, 8.2.) for the details.
3.6.1. Firmware Configuration
A. Hardware Configuration
This machine is controlled by three (3) CPUs which are located on the System Control (SC) PC
Board, the Panel Control (PNL) PC Board and the Scanner Printer Control (SPC) PC Board.
B. SC PC Board Firmware
The standard onboard Program Memory (F-ROM) mounted on the SC PCB is 4 MB. Two (2) Optional
Expansion 8 MB Program Memory (FRM8 PCB) can be installed into SLOT 1 and SLOT 2.
The Firmware to be written into the 4 MB onboard, the 8 MB of SLOT 1 / SLOT 2 depend upon the
configuration of the Standard, PCL or PS Options.
(1)
Standard
The Standard Program is only written into the 4 MB onboard, which is assigned as ROM Code (A).
(2)
For PCL Option
The PCL Control Program must be written into the 4 MB onboard, which is assigned as ROM Code
SC PC Board Standard
Configuration
With PCL Option
Configuration
With PS Option
Configuration
On Board (A)
4 MB
(B)
4 MB
(D)
4 MB
PC (1) (2) (5)
CPU
4 MB
Program Program Program
Ethernet Port
F-ROM
PC
Parallel Port Slot 1 (C) 8MB (E) 8MB
(3) (6)
Program Program
8 MB
4 MB
(a)
4 MB
(a)
FRM8 PCB
(4) (7)
Flash Memory
Card Font Program
4 MB or 8 MB
4 MB
(b)
4 MB
(b)
Slot 2
8 MB
FRM8 PCB
PNL PC Board
Panel Control Program (Display & Key In)
CPU
4 MB
Bitmap Data
F-ROM
Font Data
SPC PC Board
CPU
512 KB
Scanner Control Program
F-ROM
Printer Control Program