51
Live Monitoring Menu
Freeze
Selecting “ ” (Freeze) in the Live Monitoring menu will freeze the current image on the screen until you
select “ ” again. It is the same as pressing the (Play/Pause) button on the front panel. While in the
Freeze mode, the icon displays in bottom-left corner if “Freeze” is selected in the Display setup screen
(OSD tab).
Sequence
Selecting “ ” (Sequence) in the Live Monitoring menu causes the cameras to display sequentially. It is the
same as pressing and holding the [SEQ] button on the front panel for three seconds or longer. When in one
of the multi-view formats, pressing this button will cause the recorder to go through predefined screen layouts
(Full Sequence). Or, the bottom, right screen will display live cameras sequentially (Partial Sequence). For
example, if you press the [SEQ] button in the 2x2 format, the recorder changes pages as follows:
< Full Sequence >
< Partial Sequence >
Figure 83 : Sequence pattern
Selecting “ ” again in the Live Monitoring menu exits the Sequence mode. While in the Sequence mode,
the icon displays in bottom-left corner if Sequence is selected in the Display setup screen (“OSD” tab). If
all the cameras in a page are Off, or have lost video or are set to Covert (unless the user has authority to view
covert cameras), that page will be excluded from the sequence.
Note: The “Full Sequence” for the full sequence monitoring and the “Partial Sequence” for the
partial sequence monitoring should be selected in the Display setup screen (“Main Monitor”
tab).
The video on the Live Monitor might be distorted during a moment after sequencing.
Camera Menu
Selecting “ ” (Camera Menu) in the Live Monitoring menu displays the following Camera Menu.
Figure 84 : Camera menu
Audio
: Selecting “Audio” toggles audio output On and Off.
Color Control
: Selecting “Color Control” and choosing the camera number allows you to control
“Brightness”, “Contrast”, “Hue” and “Saturation” for each camera for the selected camera if a user who has
“Color Control” authority logs into the system. It is the same as pressing and holding a camera button for a
few seconds.
Note: It is important that cameras and monitors are correctly installed and adjusted prior to
making any image adjustments using the recorder’s controls.
Any image adjustments you make will be applied to both the live video on the monitors and
the recorded video.
Spot Monitor
: Selecting “Spot Monitor” allows you to select the camera you want to display on a Spot
monitor. Refer to the following “Spot Monitoring” section for details.
Note: The “Camera Menu” also can be displayed by clicking the right mouse button on the screen
while in the live monitoring mode.
PTZ
: Selecting “PTZ” and choosing the camera number allows you to control the selected
camera as long as it has Pan, Tilt and Zoom capabilities. It is the same as pressing the [PTZ]
button on the front panel. Refer to the following “PTZ Mode” section for details.
EL-Zoom
: Selecting “EL-Zoom” and choosing the camera number zooms the current image
of the selected camera on the screen. It is the same as pressing the [EL-Zoom] button on the
front panel. Selecting “EL-Zoom” again in the Camera Menu again exits the EL-Zoom mode.
Refer to the following “EL-Zoom Mode” section for details.
Summary of Contents for WJ-HL204/G
Page 77: ...76 Map of Screens ...
