31
2. Select a sensitivity mode for a camera (1CH) by click-
ing the pulldown list.
OFF:
Disables the motion detector function.
LOW:
Selects lower sensitivity.
MID:
Selects normal sensitivity.
HIGH:
Selects higher sensitivity.
The factory default setting is OFF.
3. Repeat the above step to designate the other camera
channels.
4. When satisfied with all of the above steps, click the
[SET]
button to execute the selections.
5. If the parameter is set to something other than OFF in
step 2, select the corresponding channel in the VMD
AREA SETUP PAGE by clicking the button.
The alarm detecting area setup window as shown in the
figure will appear on the display screen.
6. Drag the mouse pointer on the screen from the starting
point to the ending point to determine the rectangular
detecting area.
Up to four detecting areas can be set on the screen.
7. To assign an other detecting area, repeat the above
step 6.
8. To delete the area, click the rectangle to be delete on
the screen, then click the
[DELETE]
button.
9. Click the
[SET]
button to execute the selections.
10. To return to the previous window, click the
[RETURN
VMD AREA SETUP]
button.
11. Repeat the above steps 5 to 10 to set the detector func-
tion for other cameras.
12. Click the ALARM SETUP in the underneath of the VMD
AREA SETUP window to return to the previous ALARM
SETUP menu.
Summary of Contents for WJ-HDB502
Page 7: ...7 WJ HDB502 BOARD SETUP ...
Page 13: ...13 WJ HD500 SETUP ...
Page 38: ...39 SYSTEM OPERATIONS ...