Chapter 4
Settings — [PROJECTOR SETUP] menu
180 - ENGLISH
5) Press
qw
to switch the item.
[NORMAL]
Disables the indicator‑off function.
Each indicator lits or blinks depending on the status of the projector.
[OFF]
Enables the indicator‑off function.
Keep all the indicators off regardless of the status of the projector.
[TIMEOUT]
Automatically enables the indicator‑off function to turn off all the indicators if no operation is performed for the
preset time.
f
Proceed to Step
6)
when [TIMEOUT] is selected.
f
Proceed to Step
8)
when [OFF] is selected.
6) Press
as
to select [NO ACTIVITY TIME].
7) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[1 MIN.] - [15 MIN.]
Sets the time until the the indicator‑off function is enabled.
Allows you to set in increments of 1 minute. (Factory default setting: [15 MIN.])
8) Press
as
to select [NOTIFICATION].
9) Press
qw
to switch the item.
[ENABLE]
The light source indicator <LIGHT1> / <LIGHT2> and the temperature indicator <TEMP> will lit or blink
immediately when there is an occurrence of error/warning in the projector even if the indicator‑off function is
enabled, .
[DISABLE]
The indicators will not lit or blink to inform the occurrence of error/warning when the indicator‑off function is
enabled.
Note
f
If any button on the remote control or on the control panel is pressed within the preset time in [NO ACTIVITY TIME] , the [TIMEOUT] setting
does not function and the indicators do not lit or blink even the time set in [NO ACTIVITY TIME] has elapsed.
f
In following cases, the indicators will temporarily lit or blink for operation check even if the indicator‑off function is enabled.
g
right after pressing the <ON> side of the <MAIN POWER> switch to turn on the power
g
when [PROJECTOR SETUP] menu
→
[STANDBY MODE] is set to [ECO], right after pressing the <POWER ON> button in standby mode
[DATA CLONING]
Perform the operation of the data cloning function. Data such as the settings and adjustment values of the
projector can be copied to multiple projectors via LAN or using the USB memory.
For details of operation, refer to “Using the data cloning function” (
x
page 246).
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1) Press
as
to select [SAVE ALL USER DATA].
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
f
The confirmation screen is displayed.
4) Press
qw
to select [OK], and press the <ENTER> button.
f
[PROGRESS] is displayed while saving data.
Note
f
The data saved by executing [SAVE ALL USER DATA] does not include the data set with “Geometric & Setup Management Software”.
f
The data saved by executing [SAVE ALL USER DATA] is not deleted even if the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[FACTORY
RESET] is executed.
