Chapter 2
Getting Started — Connecting
58 - ENGLISH
f
Directly connect the projector with the external device that will output the signal without going through a distributor, etc., when inputting quad
link signals. A phase difference is generated between the signals of Link 1, Link 2, Link 3, and Link 4, and the image may not be projected
correctly.
f
An error in signal detection may occur when an unsteady signal is input to the projector. In such case, set the [DISPLAY OPTION] menu
→
[SLOT IN] to the content corresponding to the input signal.
Connecting example: Computers
Attention
f
When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f
When HDMI signal is input, switching of the setting in the [DISPLAY OPTION] menu
→
[HDMI IN]
→
[HDMI1] / [HDMI2]
→
[EDID SELECT]
may be required depending on the connected external device or the input signal.
f
For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. However, when the following 4K image signal
exceeding the supported transmission speed of the HDMI High Speed cable is to be input, use the HDMI cable supporting the high speed
transmission of 18 Gbps such as the one with Premium HDMI cable authentication.
g
An image signal with high specification color depth and gradation such as 3840 x 2160/60p 4:2:2/36-bit or 3840 x 2160/60p 4:4:4/24-bit
Images may be disrupted or may not be projected when an image signal exceeding the supported transmission speed of the HDMI cable is
input.
f
The <HDMI IN 1> / <HDMI IN 2> terminals of the projector can be connected to an external device equipped with a DVI-D terminal using an
HDMI/DVI conversion cable. However, this may not function properly for some external devices, and image may not be projected.
f
When DisplayPort signal is input, switching of the setting in the [DISPLAY OPTION] menu
→
[DisplayPort IN]
→
[EDID SELECT] may be
required depending on the connected external device or the input signal.
f
For the DisplayPort cable, use a DisplayPort cable that conforms to the DisplayPort standards. When a cable that does not conform to the
DisplayPort standards is used, images may be interrupted or may not be projected.
f
If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
Computer
Control computer
Control computer
Computer
