Panasonic KX-TVS80, Installation Manual

Page: 95 / 416

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Installation Manual 95
Screen output:
• The VPS tests the CPU card, the flash memory, and the
ports until "1...2...3..." is displayed.
• Active ports are displayed on the screen.
Screen output:
The display will alert you if System Setup is not completed successfully.
Screen output:
This message will appear when the DPT connection between the VPS and telephone
system cannot be established.
Possible causes of the message: "DPT Interface Connection is not Established"
Table 17
Cause Remedy
The PBX is not a correct type. Since the VPS is
configured to communicate with the default
PBX type (KX-TVS50 with the KX-TA series
under APT Integration; KX-TVS80 with the
KX-TD816/TD1232/TA1232/TD308 under
DPT Integration), this message will always
appear when connecting to another type of PBX. Connect a correct PBX and set
the PBX type by using Quick
Setup (see Section 5
CUSTOMIZING THE
SYSTEM).
The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected. Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
The PBX is a correct type but does not have the
proper software level to support APT/DPT
Integration. Contact National Parts Center
at 1-800-833-9626
or use Inband Integration under
hardware settings.
PORT TEST...
SYSTEM SETUP
1... 2... 3...
Checking Flash Memory Cards.
Please wait...
Active COs: 1 2
DPT Interface Connection is Established
** ON LINE MODE **
Active COs: 1 2
DPT Interface Connection is not Established
** OFF LINE MODE **
All manuals and user guides at all-guides.com