Panasonic KX-TVS80, Installation Manual

Page: 103 / 416

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Installation Manual 103
The display will alert you if System Setup is not completed successfully.
Screen output:
This message will appear when the DPT connection between the VPS and telephone
system cannot be established.
Possible causes of the message: "DPT Interface Connection is not Established"
10.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system’s condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER. All parameters can be set through the menu-driven program.
11.
Go to the System Administration Top Menu. Select [5] and Press ENTER, or Type [3] then
QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.
Table 18
Cause Remedy
The PBX is not a correct type. Since the VPS is
configured to communicate with the default
PBX type (KX-TVS50 with the KX-TA series
under APT Integration; KX-TVS80 with the
KX-TD816/TD1232/TA1232/TD308 under
DPT Integration), this message will always
appear when connecting to another type of PBX. Connect a correct PBX and set
the PBX type by using Quick
Setup (see Section 5
CUSTOMIZING THE
SYSTEM).
The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected. Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
The PBX is a correct type but does not have the
proper software level to support APT/DPT
Integration. Contact National Parts Center
at 1-800-833-9626
or use Inband Integration under
hardware settings.
The PBX is not programmed properly to support
APT/DPT Integration. Do required integration
programming as described in
this chapter.
Active COs: 1 2
DPT Interface Connection is not Established
** OFF LINE MODE **
All manuals and user guides at all-guides.com