Panasonic KX-TVS80, Installation Manual

Page: 90 / 416

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
90 Installation Manual
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "Checking Flash Memory Cards" is displayed on the screen.
Screen output:
• The VPS tests the CPU card, the flash memory, and
the ports until "1...2...3..." is displayed.
• Active ports are displayed on the screen.
Screen output:
The display will alert you if System Setup is not completed successfully.
Screen output:
This message will appear when the DPT connection between the VPS and telephone
system cannot be established.
Possible causes of the message: "DPT Interface Connection is not Established"
Table 16
Cause Remedy
The PBX is not a correct type. Since the VPS is
configured to communicate with the default
PBX type (KX-TVS50 with the KX-TA series
under APT Integration; KX-TVS80 with the
KX-TD816/TD1232/TA1232/TD308 under
DPT Integration), this message will always
appear when connecting to another type of PBX. Connect a correct PBX and set
the PBX type by using Quick
Setup (see Section 5
CUSTOMIZING THE
SYSTEM).
The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected. Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
PORT TEST...
SYSTEM SETUP
1... 2... 3...
Checking Flash Memory Cards.
Please wait...
Active COs: 1 2
DPT Interface Connection is Established
** ON LINE MODE **
Active COs: 1 2
DPT Interface Connection is not Established
** OFF LINE MODE **
All manuals and user guides at all-guides.com