Panasonic AJ-D93MC, Service Manual

Page: 138 / 180

MECH-60
(Adjustment)
1. Place the reels in the L size position.
2. Push the iron core of M-Stopper Solenoid by
hand.
3. Observe the clearance (A) between Mech.
Chassis and M-Stopper as shown in Figure 5-27-2.
And make sure that it is within 1.1 to 1.3mm.
4. If not, loosen the 2 screws (A), which fixed
M-Stopper Solenoid. And adjust the position of
M-Stopper Solenoid so that the clearance (A) is
within the specification. And tighten the 2 screws
(A).
Figure 5-27-2
6-1. Mech. I/F P.C. Board
5-28. T4 Post Position Adjustment
1. Confirm that the hole (B) of T4 connection Gear
match with the hole of T4 post as shown in figure
5-28-1.
2. Confirm that the portion (C) of T4 connection Gear
and hole (A). Those are located as shown in figure
5-28-1.
3. If not, adjust the phase of T4 post.
Note:
This confirmation should be performed on
unloading condition.
Figure 5-28-1
Figure 6-1-1
P15
P25 P26
P12 P16
P36
P11 P48
P21
6. CONNECTOR LOCATION