Panasonic AJ-D93MC, Service Manual

Page: 134 / 180

MECH-56
5-22-1. Cleaner Solenoid Position
Adjustment
<Tools required>
Eccentric Driver (VFK0357)
1. Press the iron core of Cleaner Solenoid.
2. Observe the clearance (D) between Cleaning Arm
Unit and Cleaner Base Plate as shown in Figure
5-22-3. And make sure that it is within 0.5 to
0.7mm.
3. If not, loosen the 2 screws (A) and adjust the
position of Cleaner Solenoid Unit by moving arrow
direction (C
←→
C) using the Eccentric drive so
that the clearance (D) is within the specification.
And tighten the 2 screws.
4. After adjustment, confirm as follows.
5. Press the iron core of Cleaner Solenoid and
released it, then the Cleaning Roller return to
original position.
6. Press the iron core of the Cleaner Solenoid and
confirm that the Cleaner Roller rotates, when the
Cylinder is rotated by hand.
Figure 5-22-2
Figure 5-22-3
Note:
If the cleaner Base Plate is removed, execute the
Cleaner roller Position adjustment.
5-22-2. Cleaner Roller Position
Adjustment
<Tools required>
Eccentric Driver (VFK0357)
1. Observe the clearance (A) between Cleaner
Roller and cylinder Unit as shown in Figure 5-22-4.
And make sure that it is within 1.0 to 1.2mm.
2. If not, loosen the 2 screws (B) as shown in figure
5-22-2 and adjust the position of Cleaner Base
Plate by moving arrow direction (A
←→
A) using
the Eccentric driver so that the clearance (A) is
within the specification. And tighten the 2 screws
(B).
Figure 5-22-4
SCREW (A)
EXPAND