Panasonic AJ-D93MC, Service Manual

Page: 126 / 180

MECH-48
5-14. Mode SW Unit Replacement
(Removal)
1. Disconnect the P22 on the MECH I/F .
2. Remove the Pinch Solenoid Unit and Loading
Motor Unit. (Refer to item 5-10 and 5-13.)
3. Remove the screw (E) and remove the Mode
Select Switch Unit from Loading Motor Unit as
shown in Figure 5-14-1.
Note:
Pay attention to the pin of Mode Switch Unit which
should match with groove of Main Cam Gear.
(Installation)
1. Install the New Mode Select Switch Unit following
the removal steps in reverse order (Refer to item
“5-13. Loading Motor Replacement”).
2. After installing the Pinch Solenoid Unit, Pinch
Solenoid Position adjustment is required. (Refer
to item 5-11).
Figure 5-14-1
5-15. Main Cam Gear Replacement
(Removal)
1. Remove the Pinch Solenoid Unit and Loading
Motor Unit. (Refer to item 5-10 and 5-13.)
2. Remove the Main Cam Gear as shown in Figure
5-15-1.
(Installation)
1. Install the Main Cam Gear, then the pin of Main
Cam Arm Unit (
∗
) should match with the groove
position of Main Cam Gear as shown in Figure
5-15-1.
2. Follow the removal steps in reverse order.
3. After installation, perform the Pinch Solenoid
Position Adjustment. (Refer to item 5-11)
Figure 5-15-1
(E)