Panasonic AJ-D93MC, Service Manual

Page: 125 / 180

MECH-47
5-12. Pinch Arm Unit Replacement
(Removal)
1. Refer to item “5-10.Pinch Solenoid Replacement”
to remove the Pinch Solenoid Unit.
2. Remove the cut washer (A) and remove the Pinch
Solenoid Lever as shown in Figure 5-12-1.
3. Remove the cut washer (B) and remove the Pinch
Arm Unit as shown in Figure 5-12-1.
(Installation)
1. Install the new Pinch Arm Unit following the
removal steps in reverse order, and then Pinch
Solenoid Position Adjustment is necessary.
Figure 5-12-1
5-13. Loading Motor Replacement
(Removal)
1. Disconnect the P21 on the MECH I/F .
2. Remove the Pinch Solenoid Unit. (Refer to item
5-10).
3. Unscrew the screw (B), and remove the
Emergency Shaft as shown in Figure 5-13-1.
4. Unscrew the 2 screws (C) and remove the
Loading Motor Neutral Unit as shown in Figure
5-13-1.
5. Unscrew the 2 screws (D) and remove the
Loading Motor Unit as shown in Figure 5-13-1.
(Installation)
1. Install the new Loading Motor Unit to Loading
Motor Neutral Unit by tightening 2 screws (D).
2. Install the Loading Motor Neutral Unit by
tightening the 2 screws (C), paying attention to the
pin of Mode SW Unit which should match with
groove position of main Cam Gear.
3. Install the Emergency Shaft by tightening the
screw (B).
4. Install the Pinch Solenoid Unit. After installation,
the Pinch Solenoid Position adjustment is required.
(Refer to item 5-11-1).
5. Connect the P21 to the MECH I/F .
Figure 5-13-1