Panametrics Aurora H2O, User Manual

Page: 71 / 170

Chapter 4. Programming Advanced Features
6 Aurora H2O User’s Manual
4.2.5 Device Discovery
The Digi module used for Ethernet connectivity supports Digi's ADDP ( Advanced Device Discovery Protocol ). ADDP
uses UDP port 2362 and a multicast IP address of 224.0.5.128. You will need to enable these on your firewall for the
ADDP protocol to work for the device discovery utility.
Digi provides two utilities,
Digi Device Discovery (for Microsoft Windows only), and Digi Port Authority (available for
Microsoft Windows, AIX, HP-UX, Solaris, and many Linux distributions). These utilities can be downloaded from the Digi
support web site at: http://www.digi.com/support/. After the utility is installed, the Aurora H2O connected to the LAN,
and the Ethernet option enabled, Device Discovery will identify it (see Figure 45 below):
Figure 45: Digi Device Discovery Screen
Advanced configuration may then be performed by opening a web browser or telnet session to the IP address listed
for the Aurora H2O. See Appendix B. “Aurora H2O Ethernet Operation” for detailed instructions.
Note: The Ethernet module is not enabled and the Aurora H2O will not be visible on the network until the Aurora
completes laser startup.