Stinger HEIGH10
®
Radio Replacement Kit
2015-2021 Chrysler 300
2015-2021 Dodge Challenger / Charger
SRK-CHR15H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-Audio.com
Pacific Accessory Corporation
Page 31
Rev: V3
Date: 032222
®
Section 4.2: Chrysler 300 Interface & Radio Module Mounting Preparation (cont.)
Part Two: Interface and Radio Module Mounting
Step 1
Step 2
Step 4
Step 3
Step 5
Step 6
With the mounting assembly face
down,
feed zip-ties through the five
mounting locations indicated.
Orientate the module as shown and
feed the zip-ties through the CH4A-
SRK mounting tabs and around
the wire harness on the right side.
Tighten and trim all zip ties.
Route the other end of the display
cables through the opening in
the mounting assembly. Leave
approximately two inches of cable
extending out the front.
From the HEIGH10 components,
plug the 8-pin and LVDS USB
display cables into the radio
module.
Position the radio module between
the side brackets and align the left
side mounting holes as shown.
Secure the radio module to the side
bracket using two M5x10 screws
from the HEIGH10 hardware.
Align the right side mounting holes
as shown. Secure the radio module
to the side bracket using two
M5x10 screws from the HEIGH10
hardware.
NOTE: Before mounting the radio module, it is recommended to plug a micro USB cable into the CH4-SRK interface. The
cable should be routed to a location in the vehicle that is accessible without disassembling the vehicle and removing the
radio if firmware updates are needed in the future.
