Stinger HEIGH10
®
Radio Replacement Kit
2015-2021 Chrysler 300
2015-2021 Dodge Challenger / Charger
SRK-CHR15H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-Audio.com
Pacific Accessory Corporation
Page 28
Rev: V3
Date: 032222
®
Step 6
Step 5
Align the locator pins on the right
side bracket spacer to
Position F
on right side of the bucket. Attach
using two #8 x 3/4” screws
Align the locator pins on the left
side bracket spacer to
Position F
on left side of the bucket. Attach
using two #8 x 3/4” screws
Section 4.1: Dodge Challenger/Charger Interface & Radio Module Mounting Preparation (cont.)
Part One: Side Brackets and Spacers (cont.)
Part Two: Interface and Radio Module Mounting
Step 1
Step 2
Step 3
With the mounting assembly
face down, place the CH4A-
SRK module as shown. Loosely
install zip ties through the module
mounting tabs and through the
anchor locations.
Install a zip tie to secure the wire
harness on the right side. Tighten
and trim all zip ties.
From the HEIGH10 components,
plug the 8-pin and LVDS USB
display cables into the radio
module.
NOTE: Before mounting the radio module, it is recommended to plug a micro USB cable into the CH4-SRK interface. The
cable should be routed to a location in the vehicle that is accessible without disassembling the vehicle and removing the
radio if firmware updates are needed in the future.
