Overland Data DLT LibraryXpress Series, Service Manual

Page: 90 / 140

82 Chapter 5 - Troubleshooting
Using CE Diagnostics
The system diagnostics are intended for use by a CE or other technically trained person. To
use system diagnostics, proceed as follows.
1. At the Default Screen, press the
Enter
button. The display will show the following.
Load/Unload
Show Status Menu
Maintenance Menu
Configure Menu
Figure 5-2 Main Menu
2. Press the button twice to move the next to Maintenance, then press the
Enter
button to select the Maintenance Menu. The display will show something similar to
the following.
Clean Drive
Diagnostic Menu
Demo Menu
Flash Update
Figure 5-3 Maintenance Submenu
3. Press the button once to move the next to Diagnostic Menu, then press the
Enter
button to select the Diagnostic Menu. The following menu will appear.
Tach Feedback
Cartridge Cycle
Scanner Feedback
Friction Test
Figure 5-4 Diagnostic Submenu
This screen is scrollable. The list of Diagnostics available is as follows.
•
Cartridge Cycle
•
Friction Test
•
Tach Feedback
•
Scanner Feedback
Of these selections, only three are intended for use in the field. Friction Test is used only
during factory setup.