Overland Data DLT LibraryXpress Series, Service Manual

Page: 83 / 140

Chapter 4 - Maintenance 75
Running the Cleaning Cartridge
This procedure assumes that the cleaning cartridge has been installed into Slot 1 of the
system.
1. On the control panel of the Global Control Module, at the Default Screen, press the
Enter
button. The display will show the following.
Figure 4-1 Main Menu
2. Press the
θ
button twice to move the next to ‘Maintenance Menu’, then press the
Enter
button to select the Maintenance Menu. The display will show something
similar to the following.
Figure 4-2 Maintenance Menu
3. Press the
Enter
button once to select Clean Drive., The following screen appears.
Figure 4-3 Cleaning Submenu
4. Lines 2 and 4 are scrollable. The choices available on Line 2 are DLT1 through
DLTn. Let us assume you want to clean DLT1. Press the
Enter
button once to
accept DLT1. The moves to line 4 of the display. Press the
Enter
button again to
use the cartridge in Slot 1. Note: If you are unable to use slot 1 for the cleaning
cartridge, you can scroll line 4 to select another slot.
5. The Clean Confirmation Screen appears, as shown below.
Load/Unload
Show Status Menu
Maintenance Menu
Configuration Menu
Clean Drive
Diagnostic Menu
Demo Menu
Flash Update
Cleaning:
✱ ✱ DLT1
Using
✱ ✱ Slot1