Overland Data DLT LibraryXpress Series, Service Manual

Page: 72 / 140

64 Chapter 3 - Operation
Figure 3-27 Load/Unload ‘From’ Entry Screen
When you have scrolled to your desired source, press the
Enter
button to select it. Notice that
in Figure 3-28, two changes occur in the display.
•
The
✱
reappears at the beginning of line 2, indicating that you have made a selection.
•
The now moves to line 4, indicating that you may now select a destination.
Figure 3-28 Load/Unload ‘To’ Entry Screen
You can now simply press the
Enter
button to select DLT1 as the destination. Note that there
is no at the end of line 4, nor at the end of line 1. There are no additional choices
because 1) you have selected a slot as the source, so the destination must be a drive, and 2)
DLT2 already has a cartridge in it, so it cannot be a valid destination. Press the
Enter
button
to select DLT1. In response, the confirmation screen in Figure 3-29 appears.
Figure 3-29 Confirmation Screen
As the confirmation screen indicates, to execute the load or unload, press the
Enter
button. If
the confirmation screen does not show your intended source and destination, press the
Escape
button to return to the ‘From’ entry screen.
When you press the
Enter
button, the screen shown in Figure 3-30 appears. If the source is a
drive, the word ‘Unload’ appears in place of the word ‘Load’ on line 4.
From:
Slot4
To:
✱ ✱
DLT1
From:
✱ ✱
Slot4
To:
✱ ✱
DLT1
From: Slot4 To:DLT1
ENTER To Execute
ESCAPE To Cancel