Overland Data DLT LibraryXpress Series, Service Manual

Page: 117 / 140

Chapter 6 - Parts Removal and Replacement 109
Replacement
Refer to Figure 6-15.
1. With the sensor behind the door, guide the sensor cable connector through the
opening in the bulkhead. Referring to Figure 6-7 and 6-8, connect it to J17 - ‘Door
Sensor’ on the Controller PWB.
2. While holding the door open, position the sensor over its mounting tabs. Install the
two M2 self-tapping screws. Do not over tighten the screws.
3. Position the magazine track over the mounting studs. Route the cable at the sensor
end between the caddy bulkhead and the mounting stud.
4. Install six M3 x 12 mm flat head Phillips screws that hold the magazine track in
place. Note: Apply Loctite 222 to the threads of each screw before inserting.
5. Replace the Power Supply Assembly as described in this chapter.
6. Replace the cover plate as described in this chapter.