Overland Data DLT LibraryXpress Series, Service Manual

Page: 115 / 140

Chapter 6 - Parts Removal and Replacement 107
Magazine Door Assembly
Removal
Refer to Figure 6-14.
1. Remove the cover plate as described in this chapter
2. Move the shuttle toward the back of the chassis so the area to the left of the door is
accessible.
3. Remove the two M4 lock nuts from the pivot block studs.
4. Slide the pivot blocks and door assembly from the mounting studs. Open the door
and rotate it as needed to clear the magazine track and the door opener mechanism.
Note: The spring ends are restrained under the chassis lip. The spring torsion will
release as you remove the assembly.
Figure 6-14 Magazine Door
Replacement
Refer to Figure 6-14.
1. Orient the door pivot blocks so that the beveled edge is up and toward the front of
the unit.
2. Position the door springs so that they are equidistant from the centerline and edges
of the door. The tang at the left of each spring should be caught in a molded notch in
the door.