Overland Data DLT LibraryXpress Series, Service Manual

Page: 120 / 140

112 Chapter 6 - Parts Removal and Replacement
Figure 6-17 Magazine Unlock/Open Switch and Magazine Security Lock
Replacement
Refer to Figure 6-17.
1. If you are not replacing the Unlock/Open Switch, skip the next four steps.
2. If necessary, separate the LED from its mount on the Unlock/Open Switch.
3. Push the LED, the 2-pin connector, and the 4-pin connector through the switch
mounting hole.
4. From behind the panel, push the LED through the hole above the switch mounting
hole. Press the LED into its mount on the back of the switch until the dome of the
LED protrudes from the front of the switch bezel.
5. Press the Unlock/Open Switch into its mounting hole.
6. If you are not replacing the Magazine Security Lock, skip the next three steps.
7. Insert the Magazine Security Lock into its mounting hole in the front panel.
8. Install the nut over the wiring onto the threaded barrel of the Magazine Security
Lock
9. Using a 15 mm open end wrench, tighten the nut. Do not over tighten.
10. Connect the Magazine Security Lock to the harness at the 2-pin connector.
11. Press the 2-pin connector set against the double-sided foam adhesive tape on the
back of the front panel.
12. Route the cable along the top edge of the Control Panel and connect to the 4-pin
connector labeled ‘Lock Switch Assy.’
13. Replace the door opener mechanism as described under the heading ‘Door
Opener/Magazine Lock Assy’ in this chapter.
14. Replace the cover plate as described in this chapter.