Overland Data DLT LibraryXpress Series, Service Manual

Page: 116 / 140

108 Chapter 6 - Parts Removal and Replacement
3. Guide the pivot blocks over the mounting studs, right side first. Twist the springs
and guide the free end under the chassis lip. Push the left pivot block to the extreme
left to clear the lip around the door opening. Note: Do not wedge the pivot blocks
into position. Excessive sideways force on the pivot block studs may cause
irreparable damage to the front panel.
4. Install two M4 lock nuts.
5. Replace the cover plate as described in this chapter.
Magazine Door Opto Sensor
Removal
Refer to Figure 6-15.
1. Remove the cover plate as described in this chapter.
2. Remove the Power Supply Assembly as described in this chapter.
3. Move the shuttle toward the back of the chassis so the area near the door is
accessible.
4. Remove the six M3 x 12 mm flat head Phillips screws that hold the magazine track
in place, and swing the front of the track toward the left of the chassis. Take care
not to stretch the sensor cable at the rear of the track.
5. While holding the door open, remove the two M3 x 8 mm screws and sems washers
that hold the sensor to the chassis.
6. Disconnect the opto sensor cable from the Controller PWB.
7. Guide the sensor cable through the opening in the bulkhead and remove the sensor.
Figure 6-15 Door Opto Sensor