Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 187 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 187
The following example specifies trap community name 1 ( name ) for SNMP:
switch_a(config)#snmp-server trap-community 1 name
switch_a(config)#
Trap Host IP Address:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to specify trap host IP address for SNMP.
Use the no parameter with this command to remove trap host IP address for SNMP.
3.
Command Syntax:
snmp-server trap-ipaddress <1-5> IP-ADDRESS
no snmp-server trap-ipaddress <1-5>
<1-5> The trap host IP address 1-5.
IP-ADDRESS The trap host IP address for SNMP. A.B.C.D specifies the IP address.
4.
Example:
The following example specifies trap host 1 IP address ( 192.168.1.20 ) for SNMP:
switch_a(config)#snmp-server trap-ipaddress 1 192.168.1.20
switch_a(config)#
Link Down Trap:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use snmp-server trap-type enable linkDown command to enable link down trap for SNMP.
Use the no snmp-server trap-type enable linkDown command to disable link down trap for SNMP.
3.
Command Syntax:
(no) snmp-server trap-type enable linkDown
4.
Example:
The following example enables link down trap for SNMP:
switch_a(config)#snmp-server trap-type enable linkDown
switch_a(config)#
Link Up Trap:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#